User:Chrisjjj/Normalising for DJing with MediaMonkey

If you are using MediaMonkey for DJing (not something I recommend), the following info might help you. It applies to MediaMonkey V4.1.3.1708 and hopefully subsequent versions.

Normalising volume

To normalise the volume of a track is to cause the track play to back at the same volume as other tracks.

You can normalise volume manually by adjusting PA volume during play.

You can normalise volume automatically, as follows:

1) Select a single track.

2) Right-click the selected track, click Analyse volume [1] and wait for the progress bar at bottom to complete.

3) Repeat from 1 for all other tracks.

Each track will now play back at very nearly the same volume as the others. Small volume differences will remain between tracks that have widely different dynamic profiles.

Do not perform step 2 on multiple selected tracks. This ignores any differences between tracks in the selection, and hence fails to normalise within the selection.

If the above procedure fails to yield normalised volume, the likely cause is that Analyse volume was previously performed on multiple tracks. This is confirmed by the Album Volume value (visible in the column enabled thus [2]) being non-empty. This can be remedied as follows:

1 Launch Mp3tag [3].

2 Load the album [4].

3 Select the affected tracks.

4 Select REPLAYGAIN_ALBUM_GAIN and execute Remove field [5].

5 In MediaMonkey select the affected tracks and execute Remove and Delete from Library only [6] (this loses any references to those tracks within playlists)

6 Execute Add/Rescan on the folder of the album containing the tracks [7].

Warning

Avoid the adjacent menu command Level track volume [8], despite its name. Use of this command is disrecommended.

Normalising gaps

To normalise gaps is to arrange that the duration of silence between each track and the next is constant.

The tracks'recordings often have a variable amount of silence at the end, and sometimes the start. Hence when a list of tracks is played automatically, the inter-track gap varies.

The milonga DJ usually wants the gap after dance tracks to be constant at 2-4s duration, and the gap after a curtain to be shorter or absent. Normalisation allows this to be achieved.

MediaMonkey does not allow full normalisation of gaps, either manually or automatically, but does allow partial normalisation that ensures some gap is always present when required.

You can partially normalise gaps manually as follows:

1) Select Clear list & play selected only [9]

2) Checkmark Remove silence at the beginning / end of track [10]

3) Double-click to play the first track. When it completes, playback will stop.

4) After an appropriate delay, double-click the next track.

This does not remove any period before track start filled with noise (e.g. hiss, crackle).

You can partially normalise gaps in a playlist automatically as follows:

1) Ensure Remove silence at the beginning / end of track is uncheckmarked [11]

2) Ensure Clear list & play selected + subsequent is selected [12]

3) In the playlist, after each track, insert a gap track -- a track consisting of a few seconds of silence. Such tracks are available in TLIB, from 02480002928928\1\49 onwards.

4) Play the list as normal.

This does not remove any gaps at start/end of tracks.

Curtains

If curtain ending is manual (by DJ manually fading the curtain and starting the next dance track), no special attention to curtains is required.

If curtain ending is automatic, relying on ending prepared by audio editing (not something I recommend), the desired start and end gap may be included during editing.